If you chose Partial Users Synchronization or Partial Users and Partial Group Synchronization on the Synchronization page and you have run the job associated with this authentication source at least once, you can choose groups for full synchronization. The groups that you list on this page are synchronized with the corresponding groups on the source server. A user is imported into the portal for every user that is a member of the fully synchronized source groups.
To choose groups for full synchronization:
To add a group, click 
Add Group; then, in
the Add Group dialog box, select the groups you want to add and click
OK. To add a group, you must have
at least Select access
to that group.
To add every group imported by this authentication
source, click Add
All Groups.
To delete a group, select the group and click
.
To select or clear all of the group check boxes, select or clear the check box to the left of Group.
To edit a group, click the group name.
If the users and groups in the portal do not match the source users and groups, the portal users are disabled and groups are deleted by default. To override deletion, you can disable users or move groups to a different folder.
To disable login for users rather than deleting the users, select Disable users instead of deleting them.
Note: You can re-enable and delete users on the Release Disabled Logins page.
To move groups to a different folder for later deletion rather than deleting groups immediately:
Select Defer deletion of groups instead of deleting.
Click Browse to choose a folder in which to store the disabled groups.
In the Change Folder dialog box, select the folder and click OK.
If users have been disabled by a user synchronization job, you can enable all these users by clicking Re-Enable Users. This may take a few minutes.
To display the page associated with this help topic: